You can find the Github project page here… Alarm System on the GitHub
and the project wiki is here… Alarm System wiki on the GitHub
The software will run on a Raspberry Pi ( or any other Debian system ) and doesn’t require the custom circuit board, so if you’ve got a Raspberry Pi, an iPhone and a some time on your hands, you can download a copy of the software by following the instructions here…Installing-the-Alarm-System
Alarm System Interface
All access attempts are logged and can be viewed through the system log files.
User accounts can be created / edited / deleted through the ‘Users’ administration screen.
Up to a maximum of 12 alarm zones can be created / edited / deleted through this screen. Zone can be renamed and configured to be active in Day mode, Night mode or neither. Chimes can also be enabled for zones when required.
The circuit board provides isolation between the 12 volt alarm and the Raspberry Pi GPIO circuits. Also uses a 3.3 volt PIC microprocessor (PIC12LF1552 ) to emulate the Radio Control transmitter, providing up to 160 RC channels.
Circuit board with a Pi
The circuit board is designed to piggy back on a Raspberry Pi. GPIO connections can be through standard header pins ( requires additional cable ), or by means of the header socket ( illustrated ).
Circuit board with a Pi and cabling
This installation has all 12 alarm input circuits connected, and a tamper loop has been created using an addition connector strip. Each alarm circuit has a 12volt power feed to drive PIR’s if required. The 12 volt and 5 volt power feeds are also routed through the screw connectors.